Functions
Interface for restoring SWC and services on vehicles equipped with CAN line. Connection to car radios provided with
the specific input.
Output signals:
Steering wheel control
Ignition +12V (car with CAN-BUS protocol only). For restoring further CAN-BUS services (lighting – reversing light –
handbrake – odometer signal), an additional module 04020 is required, which can be integrated into the 04040
interface via a simple Plug&Play connection.
Compatible brands:
ALPINE – BLAUPUNKT – CLARION – JVC – KENWOOD -PHONOCAR – PIONEER – SONY.
They must be equipped with REMOTE INPUT CABLE FOR SWC.
Connections
Connect the ISO connector on the car radio and the specific connector on the car (check the compatibility of the
interface model before connecting). Connect both cables (specific ISO and car radio control wire connection) on the
interface and then turn the ignition of the vehicle. Check that the radio responds to the car’s steering wheel
commands before completing the installation of the car sound system, fixing it on the dashboard.
Programming
Introduce a small screwdriver into the slot on the side cover (1), carefully lift it by levering downwards (2) until it
To Next Page
Loading...