Ford 2005 Explorer - Page 57

Replacing foglamp bulbs
1. Make sure the headlamp switch is
in the OFF position and then
remove the splash shield, by
removing the two screws on the
front of the fenderwell.
2. Remove the bulb socket from the foglamp by turning
counterclockwise.
3. Disconnect the electrical connector from the foglamp bulb.
Reverse steps to reinstall the bulb(s).
Replacing high-mount brakelamp and cargo lamp bulbs
To remove the brakelamp assembly:
1. Remove the two screws and lamp
assembly from vehicle.
2. Remove the bulb socket from
lamp assembly by turning it
counterclockwise and pull the bulb
straight out.
Reverse steps to reinstall the bulb(s).
Replacing license plate lamp bulbs
1. Make sure the headlamp switch is
in the OFF position, then remove
the license plate assembly.
2. Remove the bulb socket from the
lamp assembly by turning it
counterclockwise and pulling the
bulb straight out.
Reverse steps to reinstall the bulb(s).
2005 Explorer Sport Trac (p27)
Owners Guide (post-2002-fmt)
USA (fus)
Lights
57