Note: For all vehicles, the number of MYKEY(S) PROGRAMMED or
ADMIN KEYS PROGRAMMED that is displayed in the MyKey™ system
status menus will include the remote start system as an additional key in
the total count. See the Check MyKey™ system status section.
Note: For all vehicles with remote start installed, it is possible to
program all original vehicle keys as MyKeys™, in which case, you will
need to use your remote start system to reset all MyKeys™ as admin
keys by doing the following:
1. Enter the vehicle, close all doors.
2. Remote start the vehicle using your remote start fob.
3. Follow Steps 1-4 in the Clear MyKey™ section.
Troubleshooting
Condition Potential Causes
Can’t create a MyKey™ • Key in the ignition is already a
MyKey™
• Key in the ignition is the last
remaining admin key (there always
has to be at least one admin key)
• SecuriLock威 passive anti-theft
system is disabled or in unlimited
mode
• Vehicle has been started using a
remote start system that is
programmed as MyKey™. Refer to
Using MyKey™ with remote start
systems section.
Cannot program the MyKey™
optional settings
• Key in the ignition is a MyKey™
• No MyKeys™ are programmed to
the vehicle. Refer to Create a
MyKey™ section
• Vehicle has been started using a
remote start system that is
programmed as MyKey™. Refer to
Using MyKey™ with remote start
systems section.
Locks and Security
122
2011 Flex (471)
Owners Guide, 1st Printing
USA (fus)
To Next Page
Loading...
Need help?
General
