Intelligent Access Key (Type 2)
1. Remove the backup key from the transmitter.
2. Twist a thin coin under the tab
hidden behind the backup key head
to remove the battery cover. Do not
use the backup key to remove the
cover or you could damage the
intelligent access key.
3. Remove the old battery.
4. Insert a new battery with the + facing downward. Press the battery
down to make sure it is fully in the housing.
5. Snap the battery cover back onto the transmitter and install the
backup key.
Car Finder
Press the lock button on the key twice within three seconds. The horn
will chirp and the turn signals will flash. It is recommended that this
method be used to locate your vehicle, rather than using the panic
alarm.
Sounding a Panic Alarm (If Equipped)
Press the button to activate the alarm. Press the button again
or turn the ignition on to deactivate.
Note: The panic alarm will only operate when the ignition is off.
60 Keys and Remote Control
2013 C-Max Full Hybrid (34h)
Owners Guide gf, 2nd Printing
USA (fus)
To Next Page
Loading...
Need help?
General
