The tether strap anchors in your vehicle are in the following positions
(shown from top view):
• Second row bucket seats and
third-row passenger side
• Second row bench seats and
third-row passenger side
Perform the following steps to install a child safety seat with tether anchors:
Note: If you install a child seat with rigid LATCH attachments, do not
tighten the tether strap enough to lift the child seat off your vehicle seat
cushion when the child is seated in it. Keep the tether strap just snug
without lifting the front of the child seat. Keeping the child seat just
touching your vehicle seat gives the best protection in a severe crash.
1. Route the tether strap.
• Second-row outboard seat positions: Route the child safety seat tether
strap over the seat back, under the head restraint and between the
head restraint posts. If needed, remove the head restraint to improve
the fit of the child safety seat or tether strap.
Child Safety 31
2013 Flex (471)
Owners Guide gf, 4th Printing, December 2012
USA (fus)
To Next Page
Loading...
Need help?
General
