Video source selection
The MEDIA control determines
which video (VCP or Auxiliary
input) is seen on the AutoVision威
screen.
When the vehicle ignition is ON and
the system is not in VCP mode, the
AutoVision威 selects the Auxiliary
input as the video source. (If there
is not a video source connected to
the Auxiliary input jack, the screen
will be blank.)
AutoPlay feature
Your AutoVision威 system is equipped with an AutoPlay Feature. When a
video cassette is inserted into the player, video and audio sources are
automatically switched to VCP. This will override any other selections
currently made.
Indications on the VCP
The operation and status of the VCP can be checked by the indications
appearing on the LED display.
1. The Power indicator flashes on
during POWER ON and will blink
when in emergency mode.
2. The HI-FI indicator illuminates
when a HI-FI tape is loaded.
3. The HP1 indicator illuminates
when the headphone jack 1 is
plugged in.
4. The HP2 indicator illuminates
when the headphone jack 2 is
plugged in.
5. The Operation indicators illuminate when the system is powered
ON, a HIFI tape is being played, or headphones are being used.
43
21 5
Entertainment Systems
44
To Next Page
Loading...
Need help?
General
