Need help?Do you have a question about the Ford BRONCO 1968 and is the answer not in the manual?
Lists all system components and provides a pre-installation checklist for verification.
Explains basic A/C system components and introduces the control panel layout.
Details the specific functions of fan speed, mode, and temperature control levers.
Disconnect battery, drain radiator, and remove existing heater components.
Remove old air components and install firewall block-off plate.
Remove radio/controls, modify dash for new A/C controls.
Prepare firewall and position the main evaporator assembly.
Connect flex hoses and adapters to the evaporator for air distribution.
Connect the main wiring harness to system components.
Mount evaporator, route ducts, and install interior air louvers.
Connect heater hoses through firewall and install the water valve.
Prepare engine bay, remove radiator, and drill mounting holes for condenser.
Mount condenser and install liquid/discharge tubes through firewall.
Connect discharge/suction hoses to compressor and associated fittings.
Install receiver/drier, pressure switch, and connect refrigerant lines.
Connect water valve and engine supply/return lines to the heater system.
Overview of completed installation, ready for professional evacuation and charging.
Detailed instructions for proper installation of the temperature control water valve.
General| Brand | Ford |
|---|---|
| Model | BRONCO 1968 |
| Category | Automobile |
| Language | English |
To Next Page