Symptom Chart
4WD TRANSFER CASE CONTROL PLATE PWR OFF, ON
BATTERY SAVER & COURTESY ENTRY BATT SAVR OFF, ON
BATTERY SAVER & COURTESY ENTRY INT LAMPS OFF, ON
FRONT WINDSHIELD WIPER/WASHER FLUID LOW OFF, ON
FRONT WINDSHIELD WIPER/WASHER SPEED RLY OFF, ON
FRONT WINDSHIELD WIPER/WASHER WASH RLY OFF, ON
FRONT WINDSHIELD WIPER/WASHER WIPER RLY OFF, ON
HEATED WINDOW & MIRROR RLY CNTRL OFF, ON
ONE TOUCH WINDOW DOWN & ACCY DELAY ACCY RLY OFF, ON
ONE TOUCH WINDOW DOWN & ACCY DELAY ONE TOUCH OFF, ON
REAR WIPER DWN RELAY OFF, ON
REAR WIPER UP RELAY OFF, ON
REAR WIPER WASH RLY OFF, ON
WARNING LAMPS AND CHIME AJAR LAMP OFF, ON
WARNING LAMPS AND CHIME CHIME OFF, ON
WARNING LAMPS AND CHIME SBLT LAMP OFF, ON
Symptom Chart
Condition Possible Sources Action
The wipers are inoperative — front
Fuses 6 (5A), 8 (5A), 15 (5A), and
20 (5A).
Circuitry.
GEM.
Multifunction switch (wiper/washer
switch).
Wiper run/park relay.
Wiper HI/LO relay.
Windshield wiper motor.
GO to Pinpoint
Test A.
The wipers stay on continuously — front
Circuitry.
GEM.
Multifunction switch (wiper/washer
switch).
Wiper run/park relay.
Windshield wiper motor.
GO to Pinpoint
Test B.
The high/low wiper speeds do not operate correctly (intermittent wiper
mode OK) — front
GEM.
Multifunction switch (wiper/washer
switch).
Circuitry.
Wiper HI/LO relay.
GO to Pinpoint
Test C.
The intermittent wiper speed does not operate correctly (high/low
speeds OK) — front
GEM.
Multifunction switch (wiper/washer
switch).
Circuitry.
Windshield wiper motor.
GO to Pinpoint
Test D.
The washer pump is inoperative — front
Fuses 6 (5A), 8 (5A), 15 (5A), and
20 (5A).
GEM.
Multifunction switch (wiper/washer
switch).
Circuitry.
Washer pump relay.
Rear washer pump relay.
Washer pump motor.
GO to Pinpoint
Test E.
The speed dependent interval mode does not operate correctly
GEM.
Circuitry.
CENTRAL JUNCTION BOX (CJB).
Vehicle speed sensor.
GO to Pinpoint
Test F.
The wipers are inoperative — rear
Fuses 6 (5A), 8 (5A), 15 (5A), and
20 (5A).
Circuitry.
GEM.
Multifunction switch (wiper/washer
switch).
Rear wiper up relay.
Rear wiper down relay.
Rear wiper motor.
GO to Pinpoint
Test G.
The wiper will not park at the correct position — rear
GEM.
Rear wiper motor.
Circuitry.
GO to Pinpoint
Test H.
The washer pump is inoperative — rear
Fuse.
GEM.
Multifunction switch (wiper/washer
switch).
Circuitry.
Washer pump relay.
Rear washer pump relay.
GO to Pinpoint
Test J.
The wipers stay on continuously — rear
GEM.
Multifunction switch (wiper/washer
switch).
Circuitry.
GO to Pinpoint
Test K.
The low washer fluid indicator does not operate correctly
Washer fluid level switch.
GO to Pinpoint
To Next Page
Loading...
