-130-
A
The coverage area (denoted by A in
the diagram) indicates an area of up to
1.8 m from the rear bumper. There is
decreased coverage area at the outer
corners of the bumper.
FRONT SENSING SYSTEM
The front sensing system is automatically
activated when the reverse gear is
engaged and will be deactivated, once
it is put back into drive and the car
drives faster than 7 km/h. It can also be
activated by pressing the Parking Aid
button in the Interior Command Centre,
unless the gear selector is in ‘P’.
The front sensing system can be turned
off at any time by pressing the Parking
Aid button, but this will also turn off the
rear sensing system. A ‘Park Aid Off’
message will display temporarily in the
Multifunction Display when the front and
rear sensing systems have been turned
off.
Parking Aid button
Parking Aids
The coverage area (denoted by ‘A’ in
the diagram) indicates an area of up to
70 cm from the front of the vehicle and
about 15-35 cm to the side of the front
end of the vehicle.
The system sounds an audible warning
when obstacles are near either bumper
in the following manner:
• Objects detected by the front
sensors are indicated by a high-
pitched tone from the front radio
speakers.
• Objects detected by the rear
sensors are indicated by a lower-
pitched tone from the rear radio
speakers.
• The sensing system reports the
obstacle which is closest to the front
or rear of the vehicle. For example, if
an obstacle is 60 cm from the front
of the vehicle and, at the same time,
an obstacle is only 40 cm from the
rear of the vehicle, the lower-pitched
tone sounds.
• An alternating warning sounds from
the front and rear if there are objects
at both bumpers that are closer
than 25 cm.