1. Switch all of the lamps and the ignition
off.
2. Disconnect the electrical connector.
3. Turn the bulb holder counterclockwise
and remove it.
Note: You cannot separate the bulb from
the bulb holder.
Note: Do not touch the bulb glass.
Front Fog Lamp (If Equipped)
1. Switch all of the lamps and the ignition
off.
2. Use suitable tools, for example a
screwdriver and a socket wrench, to
remove the wheel arch liner fixings.
Carefully reposition the wheel arch liner
to access to the front fog lamp bulb
and electrical connector.
Note: To remove the lower push pin, use a
flat-bladed screwdriver to pull up the center
release pin.
3. Disconnect the electrical connector.
263
Flex (TP3) , enUSA, Edition date: 201801, Second Printing
Maintenance
To Next Page
Loading...
