Ford MUSTANG MACH-E 2021 - Wheel and Tire Information; Locating the Tire Information Label; DOT Uniform Tire Quality Grades

E338767
1. Connect the positive (+) jumper cable
to the positive (+) jump point of the
discharged battery vehicle.
2. Connect the other end of the positive
(+) jumper cable to the positive (+)
terminal of the booster vehicle battery.
3. Connect the negative (-) jumper cable
to the negative (-) terminal of the
booster vehicle battery.
E338540
4. Make the final connection of the
negative (-) jumper cable to the
negative (-) ground point of the
discharged battery vehicle.
5. Unlock the driver door.
Jump Starting the Vehicle
To Start Your Vehicle
1. Run the engine of the booster vehicle
at a moderately high speed.
2. Move the transmission selector lever
of the low charge vehicle to park (P).
3. Switch on the ready to drive mode.
4. Run both vehicles for a minimum of
three minutes before disconnecting the
cables.
Note: Do not switch the headlamps on
when disconnecting the cables. The peak
voltage could damage the bulbs.
Disconnect the cables in the reverse order.
61
Mustang Mach-E (CGW) Canada/United States of America, enUSA, Edition date: 202008, First-Printing
Crash and Breakdown Information