1. Insert a programmed Passive Anti-Theft System (PATS) key into the ignition and turn the key from the OFF to the
RUN position. This key must be the one that is being programmed to the MyKey® restricted status.
2. From the message center main menu, use the up and down arrow buttons to scroll to and select Settings. Press the
OK button.
3. Use the up and down arrow buttons to scroll to and select MyKey. Press the OK button.
4. Use the up and down arrow buttons to scroll to and select Create MyKey. Press the OK button.
5. Press and hold the OK button to create the MyKey®.
6. The MyKey® feature (standard restricted features) is successfully programmed into this particular key. Make sure it
is labeled for easy identification. If you would like to customize the MyKey® with the audio volume limited, maximum
speed limit, speed alert chimes, and AdvanceTrac® on/off restrictions, refer to Configuring MyKey® Optional
Restricted Features in this section.
If the vehicle is equipped with an aftermarket remote start, also refer to Using MyKey® with Aftermarket
Remote Start Systems in this section.
Configuring MyKey® Optional Restricted Features
With Base Message Center
NOTE: The following features can be restricted on a MyKey®:
audio volume level set to a pre-determined level (45% of the maximum volume)
maximum speed limit of 130 km/h (80 mph) on or off
speed alert chimes set for 75, or 90 or 105 km/h (45, or 55 or 65 mph)
AdvanceTrac® always on feature turned on or off
1. Insert an admin key into the ignition and turn the key to the RUN position.
2. Press the SETUP button until RESET FOR MYKEY SETUP is displayed.
3. Press and release the RESET button to display the MyKey® setup menus. The first programmable feature is:
MYKEY MAX MPH <80 MPH> OFF.
If you do not want to change the status of a feature that appears, press and release SETUP to accept the
current setting and display the next programmable feature.
If you want to change the status of the feature that is displayed, press RESET to turn a feature on/off (or
toggle between choices). After the feature selection has been made, press and release SETUP to accept
the current setting and display the next programmable feature.
4. Repeat the process for the next features:
MYKEY MPH TONES 45 55 65 <OFF> (choose the desired speed for the chime to sound)
MYKEY VOLUME LIMIT <ON> OFF (choose the audio volume to be limited to 45%)
MYKEY ADVTRAC CTRL ON <OFF> (choose for the AdvanceTrac® to be automatically locked on or able
to be turned on or off by the MyKey® driver)
With Optional Message Center
To Next Page
Loading...
