Need help?Do you have a question about the Ford NEWHOLLAND 2000 Series and is the answer not in the manual?
Details on cylinder head, gasket, camshaft, and connecting rods for the Ford 4000 diesel.
Details on cylinder head, gasket, crankshaft, pistons, and connecting rods for the Ford 4000 gas.
Details on cylinder block and pistons for the Ford 5000 diesel.
Details on cylinder block, pistons, head, connecting rods, and oil pan for the Ford 5000 gas.
Minor changes to Ford 2000 and 3000 engines accommodating new models.
Changes in radiator cooling fins per inch for Ford 4000 and 5000 tractors.
Differences in fuel injectors for Ford 2000 and 3000 models.
Specifications for the Ford 4000 diesel air cleaner.
Specifications for the Ford 5000 gas air cleaner.
No load and idle speeds for new model gasoline engines.
Details on 22 amp generators and regulators for new models.
Elimination of oil pressure warning light on Select-O-Speed transmissions.
Introduction of a 13-inch clutch disc for heavy-duty applications.
Details of the new double clutch assembly for Ford 2000/3000 with Live P.T.O.
Changes to release linkage for single clutch models.
Recommendations for clutch pedal free play checks and adjustments.
Reduced oil capacity for 7- and 8-speed transmissions.
Changes to reduce physical effort required for gear shifting.
Details on independent P.T.O. clutch valve operating pressure.
Changes to P.T.O. rear cover and rear axle center housing.
Differences in P.T.O. clutch plates and housing for Ford 4000.
Introduction of new brake pedals with parallel width.
Comparison of new and previous hydraulic pressure relief valves.
Changes to power assisted steering systems, including pump assemblies.
Specifications for Ford 7000 diesel engine pistons.
Details on production and service piston ring sets.
Inspection and refacing of intake and exhaust valves.
Location of the engine oil cooler in Ford 7000 tractors.
Details on connecting rods for the Ford 7000 engine.
Overview of the Ford 7000 turbocharger system.
Procedures for turbocharger removal, disassembly, and installation.
Servicing and replacement of primary and secondary air cleaner elements.
Calibration specifications for the Ford 7000 injection pump.
Overview of the Ford 7000 electrical system components.
Function and troubleshooting of the air cleaner warning light.
Wiring codes for the Ford 7000 electrical system schematic.
Overview of the alternator and solid state voltage regulator system.
Schematic diagram of the alternator system components.
Explanation of diode function and construction in the alternator.
To Next Page
General