9
2-Way Transmitter Feedback Indicators:
Vehicle has shut down, either by pressing and holding** the button
or completing the run cycle (Transmitter must be in range of the vehicle).
3 Beeps/LED Flashes
Vehicle has started.
Vehicle has received an Initiate Start Command.
Remote Start Status
Transmitter Indicators
1 Beep/LED Flash
2 Beeps/LED Flashes
Steady LED Flash
Vehicle is running.
or
Safety input triggered:
- Hood opened or gear selector moved while running in remote start
mode.
or
- Key turned in the ignition on a remote started vehicle.
or
Transmitter is out of range of the vehicle while trying to remote start or the
vehicle did not receive the command to remote start.
Long-Range 1-Way and 2-Way Remote Start System (optional)
* May be activated by a “Press & Hold”, refer to “User Selectable Options” in this manual.
** “Press & Hold” or “Pressing and Holding” refers to pushing the transmitter button for more
than 2.5 seconds.
Car Find / Panic Mode (2-Way Transmitter Only):
Press the button to activate the Car Find feature. The horn will honk and
parking lights will fl ash 6 times to assist you in fi nding your vehicle. Press and hold**
the button to activate the Panic feature. The horn will sound and the parking lights
will fl ash for approximately 30 seconds or until you press or press and hold** the
button again.
4280760 Phase 2 VSS_RMST Owners Guide_P6.indd 94280760 Phase 2 VSS_RMST Owners Guide_P6.indd 9 4/27/2017 9:41:36 AM4/27/2017 9:41:36 AM
To Next Page
Loading...