Ford Ranger 2001 User Manual

Transmission
CAUTION: The engine must be rotated only in the clockwise direction, otherwise engine damage can occur. The crankshaft, the crankshaft sprocket and the pulley are
fitted together by friction between the flange faces on each part. For that reason, the crankshaft sprocket can also be moved when the crankshaft pulley is turned in the
counterclockwise direction.
1. Disconnect the battery ground cable. For additional information, refer to Section 414-01.
2. Remove the upper gearshift lever and the outer gearshift lever boot and console assembly as an assembly. For additional information, refer to Shift Lever and Boot in this
section.
3. Raise and support the vehicle. For additional information, refer to Section 100-02.
4. If transmission disassembly is necessary, remove the drain plug, and drain the transmission fluid.
 Install the drain plug after draining all of the fluid.
5. Disconnect the electrical connector from the reversing lamp switch.
6. Disconnect the following:
1. Disconnect the electrical connector from the vehicle speed sensor (VSS).
2. Disconnect the heated oxygen sensor (HO2S) electrical connector from the bracket.
7. Disconnect the wiring harness from the bracket.
SECTION 308-03: Manual Transaxle/Transmission 2001 Ranger Workshop Manual
REMOVAL
Procedure revision date: 07/02/2003
Special Tool(s)
Remover, Hydraulic Line Connector
308-182 (T88T-70522-A)
Page
1
of
4
2001 Ranger Workshop Manual
8/25/2010
http://www.fordtechservice.dealerconnection.com/pubs/content/~WS1L/~MUS~LEN/19/S
...

Ford Ranger 2001 Specifications

General

Brand	Ford
Model	Ranger 2001
Category	Automobile
Language	English

Summary

Transmission Removal

Special Tools Required

Lists required specialized tools for the transmission removal procedure.

Initial Preparation Steps

Covers battery disconnection, interior parts removal, vehicle lifting, and fluid draining.

Electrical Connections and Sensors

Disconnecting electrical connectors for reversing lamp switch, VSS, HO2S, and wiring harnesses.

Component Removal: Starter, Driveshafts, and Exhaust

Steps to remove the starter motor, driveshafts, and exhaust system components.

Transfer Case and Clutch Line Disconnection

Removal of the transfer case (4WD) and disconnection of the clutch hydraulic line.

Transmission Support and Isolator Nuts

Supporting the transmission with a jack and loosening insulator nuts prior to main support removal.

Crossmember Removal and Final Detachment

Removing crossmember, lowering transmission for access, and final removal from the vehicle.