12 / QUICK REFERENCE GUIDE 2016 TAURUS / 13
MULTI-CONTOUR ACTIVE MOTION™ FRONT SEAT*
Use the controls
on the outside
of the driver seat
to adjust the
position, massage
and support
settings. You can
also control the
intensity of the
massage, increase
or decrease the
lumbar bolster
and cushion
support, and
adjust the height
of the bolster.
Note: The massage system turns o aer 20 minutes. The engine must
be running or the vehicle must be in accessory mode to use the feature.
Allow a few seconds for any selection to activate. The seatback and
cushion massage cannot function at the same time.
MOONROOF*
The moonroof controls are on the overhead console and
have a one-touch open and close feature. To stop it during
one-touch operation, press the control a second time.
Your moonroof includes an automatic, one-touch, express
opening, closing and venting feature.
To open, press and release the SLIDE control. The moonroof
stops short of the fully opened position. This position helps
to reduce wind noise. Press and release the control again to
fully open the moonroof. To close, pull and release the
SLIDE control.
To vent the moonroof, press and release the TILT control.
To close from a vented position, pull and hold the TILT control.
Comfort (cont’d)
DUAL ZONE AUTOMATIC CLIMATE CONTROL
Press AUTO or MY TEMP (depending
on your system) to switch on automatic
operation. Adjust to select your desired
temperature. Fan speed, air distribution,
air conditioning operation and outside
or recirculated air automatically adjust
to heat or cool the vehicle, maintaining
the desired temperature.
Press DUAL to adjust the temperature
setting on the passenger side.
To return to a single temperature, hold
down AUTO or MY TEMP for more than
two seconds.
MYKEY
®
MyKey allows you to program certain driving restrictions in order to promote good
driving habits. You can program speed restrictions, limit volume levels, force on
safety belt reminders and more. For more information, refer to the MyKey chapter
in your Owner’s Manual.
AMBIENT LIGHTING*
When activated, ambient lighting
lights footwells and cupholders with a
choice of colors. To access and make
adjustments:
1) Press the Settings icon >
Ambient Lighting.
2) Tap a color once to activate
ambient lighting. This sets the color
to the highest intensity.
3) You can drag the colors up and
down to increase or decrease
the intensity.
To switch ambient lighting o, press
the active color once or drag the active
color all the way down to zero intensity.
*if equipped *if equipped
To Next Page
Loading...
