Ford TourneoConnect Owner's Handbook

4. Connect the negative (-) terminal
of vehicle B to the engine block
or the engine mount of vehicle A
(cable 2).
CAUTIONS
Do not connect to the negative
(–) terminal of the flat battery.
Make sure that the jump leads
are clear of any moving parts.
To start the engine
1.
Run the engine of vehicle B at
moderately high speed.
2.
Start the engine of vehicle A.
3. Run both vehicles for a minimum
of three minutes before
disconnecting the leads.
CAUTION
Do not switch on the headlamps
when disconnecting the cables.
The peak voltage could blow the
bulbs.
Disconnect the cables in the reverse
order.
CHANGING THE VEHICLE
BATTERY
Vehicles with a petrol
engine
If the battery has been disconnected
the vehicle may exhibit some unusual
driving characteristics for
approximately 8 km (5 miles) after
battery reconnection while the
engine management system realigns
itself with the engine.
116
Vehicle battery

Ford TourneoConnect Specifications

General

Brand	Ford
Model	TourneoConnect
Category	Automobile
Language	English