GENERAL INFORMATION
ON RADIO FREQUENCIES
CAUTION
The radio frequency used by
your remote control can also be
used by other short distance radio
transmissions (e.g. amateur radios,
medical equipment, wireless
headphones, remote controls and
alarm systems). If the frequencies are
jammed, you will not be able to use
your remote control. You can lock
and unlock the doors with the key.
Note:
You could unlock the doors if
you press the buttons on the remote
control unintentionally.
The operating range between your
remote control and your vehicle
varies depending on the
environment.
PROGRAMMING THE
REMOTE CONTROL
You can programme a maximum of
four remote controls to use with your
vehicle (including any supplied with
your vehicle).
Note:
Make sure the anti-theft alarm
is deactivated and that all doors are
closed.
1. Turn the ignition key from position
0 to position II eight times within
10 seconds. The ignition must end
in position II and remain in this
position. The door locks will cycle
to indicate that it is now possible
to programme new remote
controls.
2. Press any button on a new
remote control within 20 seconds
of the door locks cycling. The
door locks will cycle again to
indicate that the remote control
has been successfully
programmed.
3. Repeat step 2 for all your remote
controls, including your original
remote control. Each time a new
remote control is successfully
programmed, the programming
period starts again and it is
possible to programme a new
remote control for 20 seconds.
4.
Turn the ignition to position 0. The
door locks will cycle to indicate
that the remote control
programming is ended. Only the
remote controls which you have
just programmed are now able to
lock and unlock your vehicle.
CHANGING THE REMOTE
CONTROL BATTERY
If the range of the transmitter in the
key decreases gradually, the battery
(type 3V CR 2032) should be
replaced.
23
Keys and remote controls
To Next Page
Loading...
Need help?
General
