Ford Windstar 2001 - Page 5

7. NOTE: After the cover has been installed, it may be necessary to raise the subframe back into place if it had been lowered.
Install the side cover, gasket and bolts.
8. Install the LH transaxle support and insulator. For additional information, refer to Transaxle Support Insulator in this section.
9. Install the LH wheel and tire. For additional information, refer to Section 204-04.
10. Lower the vehicle.
11. Install the upper main control cover bolts.
12. Remove the special tool.
13.
Remove the special tools.
Page
5
of
7
2001 Windstar Workshop Manual
6/13/2009
http://www.fordtechservice.dealerconnection.com/pubs/content/~WS1W/~MUS~LEN/19/
...