Device description
1.
Speaker
2.
Micro USB connector
3.
Microphone
4.
Camera
5.
Answear the call / Turning on the flashlight (after pressing
twice)
6.
Flashlight
7.
On/Off/SOS buton/Return to mine screen
8.
Function touch button - return to the start screen
The set includes
-
smartwatch
-
charging cable
-
user manual
Charging
It is recommended to use a charger of output parameters of
5V ⎓ 1A. Charger is not included in the set. Full charging time
of the watch is approximately 2 hours. Open the plug protec -
ting the micro USB port, then connect the included micro USB
cable and connect the device to a power source.
1.
Installing the SIM card
Always make sure your watch is turned off before inserting or
removing the SIM card. Never insert or remove the SIM card
when the watch is turned on. Open the back cover of the watch
by gently prying it at the top and sides until the latches are unfa-
stened. Then remove the battery, taking care not to damage the
battery cables. Remember its position. Open the micro sim card
cover by sliding it slightly to the right, and then insert the SIM
card into the slot in such a way that the sim card chip is facing
upwards to the watch screen. Then close the lock by sliding to
the left. Place the batteri in the watch in it original position, then
close the back cover by pressing the latches.
To Next Page
Loading...
