3
Operation
1. Flip the power switch “ON” located on the right side of the shredder.
2. Auto Start/Auto Stop
When the START button is pushed, the “AUTO” LED will light. Insert paper / optical me-
dia to shred. The shredder will start and stop automatically when using this function. For
optical media, feed disc one at a time.
3. Manual Operation
If paper or optical media is too small for the shredder’s sensors to detect, shred it manu-
ally. Push the START button once more and the “MANUAL” LED will light. Insert paper/
optical media to be shredded. Three minutes after shredding, the cutter automatically
stops rotating.
4. Reverse Operation
Push the REV button and the “REV” LED will light and cutters will operate in reverse. If
too much paper / optical media is inserted at one time in standard modes, the shredder
will automatically operate in reverse. If this occurs, remove the inserted paper/optical
media and shred in smaller amounts. NOTE: The maximum amount of paper to be
shredded differs according to paper quality, humidity and voltage. If the shredder is to
be used continuously, do not insert more than half of the maximum capacity.
5. Full Sensor
If the wastebasket is full, the “FULL” LED will light and the cutter will stop automatically.
Open the door, remove and empty the waste bin. Replace the waste bin, close door,
and press START to resume shredding.
Description
Set-up Guidelines
1. Install the shredder on a level surface, away from heat sources and direct sunlight.
2. Insert plug into wall outlet with the appropriate voltage, 115V. If the outlet is shared with another electronic device, the total
current should not exceed 30A (at 115V).
The Formax FD 8732HS offers high-security paper shredding and
optical media destruction in a single convenient, mobile unit. It
meets the requirements of NSA/CSS Specification 02-01 for High
Security Cross-Cut Paper Shredders and Specification 04-02 for
Optical Media Destruction Devices. The FD 8732HS is listed on
the NSA/CSS EPL, and meets the 2018 requirements for particle
size of 2mm x 2mm for DVD and Blu-ray destruction.
To Next Page
Loading...