13
-Inflate until the desired pressure is
reached.
-Never exceed the maximum pressure
recommended by the tire manufac-
turer and the maximum pressure for
the rim indicated in the table in this
manual.
-Tighten the valve (10) back on and put
the valve cap (9) back into place.
2.2.1 Checking tightness of TUBELESS tires
-Verify the tire and rim are in good condition.
-Inflate the tire to a pressure of 3 bar. Place the wheel and tire in a bucket of water,
as shown in the figure.
-Replace the tire, if it is leaking and will
not seal.
-If the leak is found in the valve zone,
remove the valve, apply grease on
the rubber part of the valve in contact
with the rim and put back in place.
-If the leak continues, replace the
valve.
NOTE: If, after all the checks mentioned above have been completed and the TUBE-
LESS system is still not satisfactory, contact your nearest FORMULA S.a.S dealer.
2.3 Removing the tires
-Remove the valve cap (9), unscrew the
valve (10) and deflate the tire.
-Starting from the side opposite the
valve, press one side of the tire with
your hands until the bead (11) is re-
leased from its seat. Let it drop into
the rim groove and continue around
the entire wheel circumference.
10
9
11
To Next Page
Loading...
