Assemble torch wrap tabs to top handle.
(Tool needed: screwdriver)
Plug in welder.
Turn it on, and squeeze trigger until wire
comes out.
Carefully tighten wire feed tension knob and
despooler knob.
Adjust wire feed speed and material thickness
switch per setup chart.
1
Install wire spool per the diagram inside the
cabinet.
2
3
4
5
6
7
Turn machine on, pull trigger on MIG gun and weld. Adjust stickout, travel speed, wire feed
speed and voltage as necessary to achieve a good weld. See reverse side for weld examples
and welding tips.
WARNING: To prevent serious injury, read manual warnings and instructions before use.
125 FC WELDER QUICK START GUIDE
To Previous Page
Loading...
