are no restrictions on the use of powder de-
tergents. Liquid detergents must not be
used when a prewash has been selected.
For cycles without prewash, they must be
added via means of a dosing ball. Deter-
gent tablets or doses must be placed in the
detergent compartment of your appliance's
dispenser box.
Technical Specifications
DIMENSIONS Height
Width
Depth
850 mm
400 mm
600 mm
LINE VOLTAGE /FREQUENCY
POWER CONSUMPTION
230 V / 50 Hz
2300 W
WATER PRESSURE Minimum
Maximum
0,05 MPa (0,5 bar)
0,8 MPa (8 bar)
Connection to water supply Type 20/27
Installation
Remove all protective packaging for transit
before using for the first time. Keep in case
needed for future transit: Transporting a
non-secured appliance may damage inter-
nal components and cause leakages and
malfunctions. The appliance can also be
damaged through physical contact.
Unpacking
2
1
Untying
AB
C
D
A
1
2
B
2
1
2
1
1
C
D
To install your washing machine at the
same level as surrounding furniture, pro-
ceed as shown on picture D.
Water supply
Install the supplied water inlet hose at the
rear of your washing machine by proceed-
ing as follows. Do not reuse an old hose.
The water inlet hose can not be extended. If
it is too short, please contact the after-sales
service.
90
O
90
O
Open the water inlet tap. Check there are
no leaks.
10
To Next Page
Loading...