ance by a person responsible for their
safety.
Children should be supervised to ensure
that they do not play with the appliance.
Personalisation
Child safety
This option provides two types of locking :
• if the option is activated after the cycle
has started, no changes to the options or
programme is possible.
The cycle runs and you must deactivate
the option to run a new cycle.
• if the option is activated before the cycle
has started, the appliance cannot be
started.
To activate child safety, turn appliance on
and press “Spin” (Schleudern/Essorage)
and “Option” (Optionen/Option) simultane-
ously until the confirmation symbol
shows on in the display. The appliance
memorises the selection of this option. To
deactivate child safety, repeat the process.
How to run a wash cycle?
Using for the first time
• Ensure the electrical and water con-
nections comply with the installation
instructions.
• Remove the polystyrene insert and
all other items inside the drum.
• Run an initial wash cycle at 90°C,
without any washing but with deter-
gent to clean the water tank.
Daily Use
Loading washing
• Open the lid of
the appliance.
• Open the drum
by depressing
the locking but-
ton A: The two
shutters unlock
automatically.
•Load the wash-
ing, close the
drum and the lid of your washing ma-
chine.
Warning! Before closing the lid of your
appliance, ensure that the drum is
properly closed :
• When the two shutters are closed,
• locking button A released.
Proportioning of detergents
Pour the amount of washing into the wash-
ing
and prewash compartments if
you have selected the “prewash” option.
Pour fabric softener into the compartment
if necessary.
A
Selection of desired programme
Turn the programme selector to the re-
quired programme. The “Start/Pause”
pushbutton flashes green.
If you turn the programme selector to an-
other programme while a cycle is in pro-
gress, the appliance will ignore the new se-
lected programme. “Err” flashes and the
“Start/Pause” pushbutton flashes red for a
few seconds.
Selecting the spin speed
Press the “Spin” (Schleudern/Essorage)
pushbutton to change the spin speed.
The maximum spin speeds are :
for Cottons : 1300 rpm, for Synthetics,
Wool, Handwash, Jeans, Sport : 900 rpm,
for Delicates, Curtains : 700 rpm.
At the end of the programme, if you have
selected “Rinse hold”
, you then need to
select a “Spin” or “Drain” programme to fin-
ish the cycle and empty the water.
Selecting options
You must select the different options after
selecting the programme and before press-
ing the “Start/Pause” pushbutton (see “Pro-
gramme table”). Press the desired but-
4
To Next Page
Loading...