Turning on the Appliance
Starting a wash cycle...
Draw out the lower and upper basket, load the dishes and
1. push them back. It is recommended to load the lower basket first, then the upper one (see the
section entitled "Loading the Dishwasher"). Pour in the detergent (see the section entitled "Salt,
Detergent and Rinse Aid").
2. Insert the plug into the socket.
NOTE: A click could be heard when the door is closed perfectly.
When the washing is over, you can shut off the switch by pressing"Power" button.
Press"Power" button to cancel the programme, and turn on it again ,then you can change the
programme to the desired cycle setting (see the section entitled "Starting a wash cycle. . . " ).
NOTE: If you open the door when washing, the machine pauses and warning alarm rings, the
The 6 program lights show the state of the dishwasher:
a) One of the program lights on--> cycle running
b) One of the program lights blinking -->pause
NOTE: If all the lights begin to glimmer, that indicates the machine is out of order, please turn off
the main power and water supply before calling a service.
21
Change the Program
You must have:120-volt,60Hz,AC-only,10-or 12-amp,fused electrical supply.
Make sure that the water supply is turned on to full pressure. Open the door, press the "Power“
button, Press the "Program" button to select a desired "Wash cycle". (See the section entitled
"Wash Cycle Table" ) .Press the Start/Pause button and close the door within 4 seconds and the
dishwasher will be activated. If the door is not closed within 4 seconds after pressing the
Start/Pause button, the LED 14 is off. In this state, the door is closed and the dishwasher will not
start. Press the Start/Pause button again, the LED14 indicator lights up, and the door is closed
within 4 seconds. The dishwasher will be activated.
Prerequisite: The ongoing cycle can only be modified if the dispenser cover is not open (the door
can be opened for viewing).
Otherwise, the detergent may have already been released, and the appliance may have already
drained the wash water. If this is the case, the detergent dispenser must be refilled (see the
section entitled " Fill in the Detergent " ).
display appears E1. You need press the Start/Pause button and close the door within 4 seconds
and the dishwasher will be continue working. If the door is not closed within 4 seconds after
pressing the Start/Pause button, the LED 14 is off. In this state, the door is closed and the
dishwasher will not start. Press the Start/Pause button again, the LED14 indicator lights up, and
the door is closed within 4 seconds，The dishwasher will be continue working.
To Next Page
Loading...
