Fortinet 548B - Page 107

- 107 -
7.2.8.11 ipv6 mld snooping max-response-time
The user can go to the CLI Interface Global/Interface Configuration Mode to set the MLD Maximum
Response time for the system, on a particular interface, use the ipv6 mld snooping
max-response-time <1-65> global/interface configuration command. Use the no ipv6 mld snooping
max-response-time return to default value 10.
Syntax
Ipv6 mld snooping max-response-time <1-65>
no ipv6 mld snooping max-response-time
Default Setting
10
Command Mode
Global Config
Interface Config
7.2.8.12 ipv6 mld snooping mcrtrexpiretime
The user can go to the CLI Interface Global/Interface Configuration Mode to set the Multicast Router
Present Expiration time for the system or on a particular interface, use the ipv6 mld snooping
mcrtrexpiretime <0-3600> global/interface configuration command. Use the no ipv6 mld snooping
mcrtrexpiretime to return to default value 0.
Syntax
ipv6 mld snooping mcrtrexpiretime <0-3600>
no ipv6 mld snooping mcrtrexpiretime
Default Setting
0
Command Mode
Global Config
Interface Config
7.2.8.13 ipv6 mld snooping mrouter interface
The user can go to the CLI Interface Configuration Mode to configure the interface as a multicast
router-attached interface or configure the VLAN ID for the VLAN that has the multicast router attached
mode enabled, use the ipv6 mld snooping mrouter interface interface|<vlanId> interface
configuration command. Use the no ipv6 mld snooping mrouter interface|<vlanId> disable multicast
router attached mode for the interface or a VLAN.