Fortinet 548B - Page 123

- 123 -
Interface Config
This command set <actor | partner> admin state value of Link Aggregation Control Protocol (LACP) on a
port.
Syntax
lacp <actor|partner> admin state <individual|longtimeout|passive>
no lacp <actor|partner> admin state <individual|longtimeout|passive>
individual - Set lacp admin state to individual. Use no form to set to aggregation.
longtimeout - Set lacp admin state longtimeout. Use no form to set to shorttimeout.
passive - Set lacp admin state passive. Use no form to set to active.
no - This command restores <actor | partner> admin state value of Link Aggregation Control
Protocol (LACP) on a port.
Default Setting
no lndividual (aggregation)
no longtimeout (shorttimeout)
no passive (active)
Command Mode
Interface Config
This command set <actor | partner> port priority value of Link Aggregation Control Protocol (LACP) on a
port.
Syntax
lacp <actor|partner> port priority <priority-value>
no lacp <actor|partner> port priority
<priority-value> – range 0-255.
no - This command restores <actor | partner> port priority value of Link Aggregation Control Protocol
(LACP) on a port.
Default Setting
128
Command Mode
Interface Config