Fortinet 548B - Page 124

- 124 -
This command set <actor | partner> system priority value of Link Aggregation Control Protocol (LACP).
Syntax
lacp <actor|partner> system priority <priority-value>
no lacp <actor|partner> system priority
<priority-value> – range 0-65535.
no - This command restores <actor | partner> system priority value of Link Aggregation Control
Protocol (LACP).
Default Setting
32768
Command Mode
Interface Config
This command set collector max-delay time of Link Aggregation Control Protocol (LACP) on a
port-channel.
Syntax
lacp collector max-delay <delay-value>
no lacp collector max-delay
<delay-value>: 0-65535
no - This command restores collector max-delay time of Link Aggregation Control Protocol (LACP)
on a port-channel
Default Setting
0
Command Mode
Interface Config
7.2.10.12 channel-group
This command adds one port to the port-channel (LAG). The first interface is a logical slot and port
number of a configured port-channel.
i
Before adding a port to a port-channel, set the physical mode of the port. See ‘speed’
command.