- 160 -
Default Setting
24
Command Mode
Line Config
7.3.3 Telnet Session Commands
7.3.3.1 telnet
This command establishes a new outbound telnet connection to a remote host.
Syntax
telnet <host> [port] [debug] [line] [echo]
<host> - A hostname or a valid IP address.
[port] - A valid decimal integer in the range of 0 to 65535, where the default value is 23.
[debug] - Display current enabled telnet options.
[line] - Set the outbound telnet operational mode as ‘linemode’, where by default, the operational
mode is ‘character mode’.
[echo] - Enable local echo.
Default Setting
None
Command Mode
Privileged Exec
User Exec
7.3.3.2 show line vty
This command displays telnet settings.
Syntax
show line vty
Default Setting
None
To Next Page
Loading...
