Fortinet 548B - Page 396

- 396 -
Default Setting
None
Command Mode
Global Config
7.22.2.9 ip access-list rename
Use this command to change the name of an IP Access Control List (ACL). The <name> parameter is
the names of an existing IP ACL. The <newname> parameter is a case-sensitive alphanumeric string
from 1 to 31 characters uniquely identifying the IP access list.
Syntax
ip access-list rename <name> <newname>
Default Setting
None
Command Mode
Global Config
7.23 IPv6 ACL Command
7.23.1 Show Commands
7.23.1.1 show ipv6 access-lists
This command displays an IPv6 access list and all of the rules that are defined for the IPv6 ACL. Use the
[name] parameter to identify a specific IPv6 ACL to display.
Syntax
show ipv6 access-lists [<name>]
<name> - ACL name which uniquely identifies the IPv6 ACL to display.
Default Setting
None