Fortinet 548B - Page 73

- 73 -
7.2.3.19 switchport forbidden vlan
This command used to configure forbidden VLANs.
Syntax
switchport forbidden vlan {add | remove} <vlan-list>
no switchport forbidden
<vlan-list> - VLAN ID (Range: 1 –3965) – separate non-consecutive IDs with ',' and no spaces and
no zeros in between the range; Use '-' for range.
add - VLAND ID to add.
remove - VLAND ID to remove.
no - Remove the list of forbidden VLANs.
Default Setting
None
Command Mode
Interface Config
7.2.3.20 switchport priority
This command configures the default 802.1p port priority assigned for untagged packets for a specific
interface.
Syntax
switchport priority <0-7>
<0-7> - The range for the priority is 0 - 7.
Default Setting
0
Command Mode
Interface Config
This command configures the port priority assigned for untagged packets for all ports presently plugged
into the device. Any subsequent per port configuration will override this configuration setting.
Syntax