Fortinet 548B - Page 74

- 74 -
switchport priority all <0-7>
<0-7> - The range for the priority is 0-7.
all – All interfaces
Default Setting
0
Command Mode
Global Config
7.2.3.21 switchport protocol group
This command adds the physical <slot/port> interface to the protocol-based VLAN identified by
<group-name>. A group may have more than one interface associated with it. Each interface and
protocol combination can only be associated with one group. If adding an interface to a group causes
any conflicts with protocols currently associated with the group, this command will fail, and the
interface(s) will not be added to the group.
Syntax
switchport protocol group <group-name>
no switchport protocol group <group-name>
<group-name> - a VLAN Group Name (a character string of 1 to 16 characters).
no - This command removes the interface from this protocol-based VLAN group that is identified by
this <group-name>.
Default Setting
None
Command Mode
Interface Config
This command adds a protocol-based VLAN group to the system. The <group-name> is a character
string of 1 to 16 characters. When it is created, the protocol group will be assigned a unique number that
will be used to identify the group in subsequent commands.
Syntax
switchport protocol group <group-name>
no switchport protocol group <group-name>
<group-name> - a VLAN Group Name (a character string of 1 to 16 characters).