Page 8
Industry Canada Statement
This device complies with RSS-210 of the Industry Canada Rules. Operation is subject to the
following two conditions: (1) This device may not cause harmful interference, and (2) this device must
accept any interference received, including interference that may cause undesired operation.
Règlement d’Industry Canada
Ce dispositif est conforme à la norme CNR-210 d’Industrie Canada applicable aux appareils radio
exempts de licence. Son fonctionnement est sujet aux deux conditions suivantes: (1) le dispositif ne
doit pas produire de brouillage préjudiciable, et (2) ce dispositif doit accepter tout brouillage reçu, y
compris un brouillage susceptible de provoquer un fonctionnement indésirable.
Radiation Exposure Statement:
This equipment complies with IC radiation exposure limits set forth for an uncontrolled environment.
This equipment should be installed and operated with minimum distance 21cm between the radiator
& your body.
Déclaration d’exposition aux radiations:
Cet équipement est conforme aux limites d’exposition aux rayonnements IC établies pour un
environnement non contrôlé. Cet équipement doit être installé et utilisé avec un minimum de 21 cm
de distance entre la source de rayonnement et votre corps.
European Conformity (CE) - EU
This is a Class B product. In a domestic environment, this product may cause radio interference, in
which case the user may be required to take adequate measures.
Grounding
Ensure your Fortinet product is connected and properly grounded to a lightning and surge protector.
WAN or LAN connections that enter the premises from outside the building should be connected to
an Ethernet CAT5 (10/100 Mb/s) surge protector.
Shielded Twisted Pair (STP) Ethernet cables should be used whenever possible rather than
Unshielded Twisted Pair (UTP).
Do not connect or disconnect cables during lightning activity to avoid damage to your Fortinet
product or personal injury.
Electrostatic discharge (ESD) can damage Fortinet equipment. Only perform the procedures
described in this document from an ESD workstation. If no such station is available, you can
provide some ESD protection by wearing an anti-static wrist strap and attaching it to an available
ESD connector or other bare metal object.
Caution: Risk of explosion if battery is replaced by an incorrect type. Dispose of used batteries
according to your local regulations.
Caution: Fuses are only replaceable by authorized service personnel.
To Next Page
Loading...
