Log & Report Log config
FortiGate-500 Administration Guide 01-28006-0007-20041105 363
4 Select OK.
5 Repeat steps 1 through 4 for each interface for which you want to enable logging.
6 Make sure you enable traffic logs for a logging location and set the logging severity
level to Notification or lower.
To enable traffic logging for a firewall policy
You can enable traffic logging for a firewall policy. All connections accepted by the
firewall policy are recorded in the traffic log.
1 Go to Firewall > Policy.
2 Select the Edit icon for a policy.
3 Select Log Traffic.
4 Select OK.
5 Make sure you enable traffic log under Log Filter for a logging location and set the
logging severity level to Notification or lower.
To Next Page
Loading...
