A limited Command Line Interface (CLI) is available for basic device
configuration and debugging purposes. The FortiSandbox device is
primarily configured using the Web-based Manager.
To connect to the CLI:
1. Connect the FortiSandbox unit console port to the management
computer using the provided console cable.
2. Start a terminal emulation program on the management computer.
Select the COM port and use the following settings:
• Baud Rate: 9600
• Data bits: 8
• Parity: None
• Stop bits: 1
• Flow Control: None
3. Press Enter on your keyboard to connect to the CLI.
4. Type admin in the Name field, leave the Password field blank, and
press Enter.
You can now proceed with configuring your FortiSandbox unit.
To Next Page
Loading...
