Fortinet FortiSwitch-548B v. 5.2.0.2 - Page 182

- 182 -
Default Setting
None
Command Mode
Global Config
7.3.7 HTTP commands
7.3.7.1 show ip http
This command displays the http settings for the switch.
Syntax
show ip http
Default Setting
None
Command Mode
Privileged Exec
Display Message
HTTP Mode (Unsecure): This field indicates whether the HTTP mode is enabled or disabled.
HTTP Port: This field specifies the port configured for HTTP.
HTTP Mode (Secure): This field indicates whether the administrative mode of secure HTTP is
enabled or disabled.
Secure Port: This field specifies the port configured for SSLT.
Secure Protocol Level(s): The protocol level may have the values of SSL3, TSL1, or both SSL3
and TSL1.
Hard-timeout: Display the hard timeout for secure HTTP sessions in hours.
Soft-timeout: Display the soft timeout for HTTP sessions in minutes.
Max-sessions: Display the number of allowable HTTP sessions.
Secure-hard-timeout: Display the hard timeout for secure HTTP sessions in hours.
Secure-soft-timeout: Display the soft timeout for HTTP sessions in minutes.
Secure-max-sessions: Display the number of allowable HTTP sessions.
7.3.7.2 ip javamode
This command specifies whether the switch should allow access to the Java applet in the header frame
of the Web interface. When access is enabled, the Java applet can be viewed from the Web interface.
When access is disabled, the user cannot view the Java applet.