Fortinet FortiSwitch-548B v. 5.2.0.2 - Page 429

- 429 -
Default Setting
Disabled
Command Mode
Interface Config
8.2.2.2 ip routing
This command enables the IP Router Admin Mode for the master switch.
Syntax
ip routing
no ip routing
no - Disable the IP Router Admin Mode for the master switch.
Default Setting
Disabled
Command Mode
Global Config
8.2.2.3 ip address
This command configures an IP address on an interface. The IP address may be a secondary IP
address.
Syntax
ip address <ipaddr> <subnet-mask> [secondary]
no ip address <ipaddr> <subnet-mask> [secondary]
<ipaddr> - IP address of the interface.
<subnet-mask> - Subnet mask of the interface.
[secondary] - It is a secondary IP address.
no - Delete an IP address from an interface.
Default Setting
None
Command Mode
Interface Config