Fortinet FortiSwitch-548B v. 5.2.0.2 - Page 466

- 466 -
Syntax
router-id <ipaddress>
Default Setting
None
Command Mode
Router OSPF Config Mode
8.3.2.47 redistribute
redistribute command configures OSPF protocol to allow redistribution of routes from the specified
source protocol/routers. no redistribute command configures OSPF protocol to prohibit redistribution of
routes from the specified source protocol/routers.
Syntax
redistribute {rip | bgp | static | connected} [metric <0-16777214>] [metric-type {1 | 2}] [tag
<0-4294967295>] [subnets]
no redistribute {rip | bgp | static | connected} [metric <0-16777214>] [metric-type {1 | 2}] [tag
<0-4294967295>] [subnets]
Default Setting
metric—unspecified
type—2
tag—0
Command Mode
Router OSPF Config Mode
8.3.2.48 maximum-paths
maximum-paths command sets the number of paths that OSPF can report for a given destination
where maxpaths is platform dependent. no maximum-paths command resets the number of paths that
OSPF can report for a given destination back to its default value.
Syntax
maximum-paths <maxpaths>
no maximum-paths
Default Setting
4