Fortinet FortiSwitch-548B v. 5.2.0.2 - Page 527

- 527 -
9.6.2 Configuration Commands
9.6.2.1 ip pimsm
This command sets administrative mode of PIM-SM multicast routing across the router to enabled.
IGMP must be enabled before PIM-SM can be enabled.
Syntax
ip pimsm
no ip pimsm
no - This command sets administrative mode of PIM-SM multicast routing across the router to
disabled. IGMP must be enabled before PIM-SM can be enabled.
Default Setting
Disbaled
Command Mode
Global Config
9.6.2.2 ip pimsm join-prune-interval
This command is used to configure the global join/prune interval for PIM-SM router. The join/prune
interval is specified in seconds. This parameter can be configured to a value from 0 to 18000.
Syntax
ip pimsm join-prune-interval <0 - 18000>
no ip pimsm join-prune-interval
<0 - 18000> - This is time interval in seconds.
no - This command is used to reset the global join/prune interval for PIM-SM router to the default
value.
Default Setting
60
Command Mode
Interface Config