Fortinet FortiSwitch-548B v. 5.2.0.2 - Page 596

- 596 -
Default Setting
Disabled
Command Mode
Router OSPFv3 Config.
10.4.2.37 redistribute
This command configures the OSPFv3 protocol to allow redistribution of routes from the specified
source protocol/routers.
Syntax
redistribute {static | connected} [metric <0-16777214>] [metric-type {1 | 2}] [tag <0-4294967295>]
no redistribute { static | connected} [metric] [metric-type] [tag]
<0-16777215> - The range of metric is 0 to 16777214.
<0-4294967295> - The range of tag is 0 to 4294967295.
Default Setting
Metric is unspecified.
Type is 2.
Tag is 0.
Command Mode
Router OSPFv3 Config
10.4.2.38 router-id
This command sets a 4-digit dotted-decimal number uniquely identifying the router ospf id.
Syntax
router-id <ipaddress>
<ipaddress> - IP Address.
Default Setting
None
Command Mode
Router OSPFv3 Config