Fortinet FortiSwitch-548B v. 5.2.0.2 - Page 598

- 598 -
Info Time: Configured value.
Enable Ripng of interfaces: List all interfaces enabled RIPng.
Enable passive mode of interfaces: List all interfaces enabled RIPng passive.
10.5.2 Configuration Commands
10.5.2.1 enable
This command resets the default administrative mode of RIPng in the router (active).
Syntax
enable
no enable
no - This command sets the administrative mode of RIPng in the router to inactive.
Default Setting
Enabled
Command Mode
IPv6 Router RIP Config
10.5.2.2 ipv6 rip
This command enables RIPng on a router interface.
Syntax
Ipv6 rip
no ipv6 rip
no - This command disables RIPng on a router interface.
Default Setting
Disabled
Command Mode
Interface Config