Fortinet FortiSwitch-548B v. 5.2.0.2 - Page 611

- 611 -
Default Setting
0
Command Mode
Global Config
10.7.2.6 ipv6 pimsm spt-threshold
This command is used to configure the Data Threshold rate for the last-hop router to switch to the
shortest path. The rate is specified in Kilobits per second. The possible values are 0 to 2000.
Syntax
iipv6 pimsm spt-threshold <1-2000>
no ipv6 pimsm spt-threshold
no - This command is used to set the Data Threshold rate for the RP router to the default value.
Default Setting
0
Command Mode
Global Config
10.7.2.7 ipv6 pimsm ssm
Use this command to define the Source Specific Multicast (SSM) range of IP multicast addresses.
Syntax
ipv6 pimsm ssm {default | <group-address> <group-mask>}
no ipv6 pimsm ssm
default - Defines the SSM range access list to 232/8.
no - This command is used to disable the Source Specific Multicast (SSM) range.
Default Setting
Disbaled
Command Mode
Global Config