- 875 -
Border router is translating type-7 LSAs into type-5.' Disabled' implies tha a candidate NSSA Border
router is NOT translating type-7 LSAs into type-5.
Command Buttons
Create Stub Area - Configure the area as a stub area.
Delete Stub Area - Delete the stub area designation. The area will be returned to normal state.
Create NSSA - Configure the area as NSSA.
Delete NSSA - Delete the NSSA designation. The area will be returned to normal state.
Submit - Send the updated configuration to the switch. Configuration changes take effect
immediately. These changes will not be retained across a power cycle unless a save is performed.
11.6.7.3 Viewing OSPFv3 Stub Area Summary Page
Non-Configurable Data
Area ID - The Area ID of the Stub area
Metric Value - The metric value applied to the default route advertised into the area.
Import Summary LSAs - Whether the import of Summary LSAs is enabled or disabled.
Command Buttons
Refresh - Refresh the data on the screen to the current values from the switch.
11.6.7.4 Configuring OSPFv3 Area Range Configuration Page
Selection Criteria
Area ID - Selects the area for which data is to be configured.
To Next Page
Loading...
