After connecting to the FortiVoice appliance, run the quick start wizard to set up
the basic network and PBX settings.
For detailed instructions, see the FortiVoice Administration Guide.
Shutting down the FortiVoice appliance
Always properly shut down the FortiVoice appliance’s operating system before
turning off the power switch or unplugging it. This causes it to finish writing any
buffered data, and to correctly spin down and park the hard disks.
Do not unplug or switch off the FortiVoice appliance without first halting
the operating system. Failure to do so could cause data loss and hardware
problems.
To power off the appliance via the web UI
1. Connect to the web UI.
2. Go to System > Status.
3. In the System Command widget, click the Shut Down button.
You may be able to hear the appliance become more quiet when the appliance
halts its hardware and operating system, indicating that power can be safely
disconnected.
4. Disconnect the power cable from the power supply.
To power off the appliance via the CLI
1. Connect to the CLI.
2. Enter the following command:
execute shutdown
You may be able to hear the appliance become more quiet when the appliance
halts its hardware and operating system, indicating that power can be safely
disconnected.
3. Disconnect the power cable from the power supply.
Page 3
Configuring FortiVoice
To Next Page
Loading...
