Fortress Technologies FFW1012C11E User Manual

EN
17
the auxiliary temperature
appears
on the temperature indicator (13b).
To adjust the temperature, press
the temperature button (Figure 2-9).
Temperature falls with 10° decrements.
Cold selection is shown with “-” symbol.
When the “Temperature” button is
pressed after coming to the Cold
selection, the maximum temperature of
the program you have selected will be
displayed.
To decrease the temperature, press the
“Temperature” button again.
90C
Normally soiled, white
cotton and linens. (eg.:
coffee table covers,
tablecloths, towels, bed
sheets)
60C
Normally soiled, fade proof
colored linens, cotton
or synthetic clothes
(eg.: shirts, nightgowns,
pajamas) and lightly soiled
white linen clothes (eg.:
underwear)
40C-
30°C-
Cold
For delicate clothes (eg.: veil
curtains), blended clothes
including synthetics and
woolen.
Spin Speed selection
Whenever a new program is selected,
the maximum spin speed of the selected
program is displayed on the spin speed
indicator (Figure 3-13a).
To decrease the spin speed, press
the “Spin” button (Figure 2-7). Spin
speed decreases gradually. Then, rinse
hold and no spin options are shown
respectively.
Rinse hold is shown with “
”，
sNo pin is shown with “
”.
If you do not want to unload your
clothes immediately after the program,
you may use the rinse hold function
in an anhydrous condition.
With this function, your laundry is kept
in the final rinsing water. If you want to
to
reduce the creases of your clothes
spin your laundry after the rinse hold
function:
- Adjust the spin speed.
- Press Start/Pause/Cancel Button.
Program resumes. Your machine
drains the water and spins your
laundry.
You can use no spin function in
order to
drain the water without spinning
at the
the
end of the program.
e

Fortress Technologies FFW1012C11E Specifications

General

Brand	Fortress Technologies
Model	FFW1012C11E
Category	Washer
Language	English