EN
8
Removing packaging
reinforcement
Tilt the machine to remove the
packaging reinforcement. Remove the
packaging reinforcement by pulling the
ribbon.
Opening the transportation
locks
Transportation safety bolts must
be removed before operating the
washing machine! Otherwise, the
machine will be damaged!
1. Loosen all the bolts with a spanner
until they rotate freely (“C”)
2. Remove transportation safety bolts
by turning them gently.
3. Fit the covers (supplied in the bag
with the Operation Manual) into the
holes on the rear panel. (“P”)
Keep the transportation safety
bolts in a safe place for reuse when
the washing machine needs to be
moved again in the future.
Never move the appliance without
the transportation safety bolts
properly fixed in place!
Appropriate installation
location
Install the appliance in environments
which have no risk of freezing, in a
stable and level position.
The floor must be capable of
carrying the load on it!
If the washing machine and a drier
are placed on top of each other,
their approximate weight together
may reach 180 kg when they are
full.
Important:
Do not place the appliance on top of
the power cable.
Keep at least 1cm distance from the
edges of other furniture.
Place the machine on a firm surface;
do not position it on a long pile rug
or such like surfaces.
Adjusting the feet
Do not use any tools to loosen the
locknuts. Otherwise, they can be
damaged.
1. Manually (by hand) loosen the
locknuts on the feet.
2. Adjust them until the machine
stands level and firm.
Installation
To Next Page
Loading...
Need help?
General
