Fortress Technologies FFW1212C11E User Manual

EN
9
3. Important: Tighten all locknuts up
again.
Connecting to the water
supply.
Important:
 The water supply pressure required
to run the machine must be 1-10
bar
(0,1 – 1,0 MPa). Attach a
pressure
-reducing valve if the water
pressure
is higher than the requirement.
 Connect the special hoses supplied
with the machine to the water intake
valves on the machine.
 If you are going to use your double
water-inlet machine as a single
(cold) water-inlet unit, you must
install the stopper*, supplied with
your machine to the hot water valve.
If you want to use both water inlets
of the product, you can connect the
hot water hose after removing the
stopper and gasket group from the
hot water valve.
* Applies for the products supplied
with a blind stopper group.
 Open the taps completely after
making the hose connection to
check if there is any water leakage
at the connection points. Turn off
the tap and remove the nut in case
of any leakage. Retighten the nut
carefully after checking the seal.
To prevent any water leakage and
any other damage，
keep the taps
closed when the
machine is not
in use.
 Models with a single water inlet
should not be connected to the
hot water tap. Laundry may be
damaged or the appliance may
switch to protection mode and not
work.
When returning the appliance to its
place after maintenance or cleaning,
care should be taken not to fold,
squeeze or block th
e hoses.
Connecting to the drain
The water discharge hose can be
attached to the edge of a washbasin or
bathtub. The drain hose should be firmly
fitted into the drain as to not loosen in
its housing.
Important:
The new hose-sets supplied with the
appliance are to be used and that
old hose-sets should not be reused.
 The end of the drain hose can
be directly connected to the
wastewater drain or to the
washbasin. The fitting must be
secured in all types of connections.
Your house may be flooded if the
hose falls out of its housing during
water discharging.
 The hose should be attached to a
height of at least 40 cm and 100
cm at most.

Fortress Technologies FFW1212C11E Specifications

General

Brand	Fortress Technologies
Model	FFW1212C11E
Category	Washer
Language	English