Need help?Do you have a question about the FOS Technologies Cyclone RGB and is the answer not in the manual?
General| Brand | FOS Technologies |
|---|---|
| Model | Cyclone RGB |
| Category | Test Equipment |
| Language | English |
Details voltage, power, light source, luminosity, beam angle, control, DMX channels, protection class, dimensions, and weight.
Warning about prolonged continuous flashing of the strobe.
Instructions for qualified installation, maintenance, ventilation, distance from surfaces, and disconnecting power.
Explains the IP-Code system for classifying protection levels against solids and water.
Lists and explains different IP ratings (IP20, IP33, IP54, IP65, IP67) and their typical uses.
Discusses the design of event equipment for temporary use and potential aging of materials.
Discusses how IP ratings are affected by environmental factors like sunlight and UV, and material aging.
Describes hanging and upright mounting methods using brackets and safety cables.
Notes the need for a DMX signal amplifier for long cable runs between fixtures or controller.
Explains how to navigate through menu options using the fixture's buttons.
Lists and briefly describes available menu options like Addr (DMX address) and Chnd (channel mode).
Details specific menu options like LED, disp, bala, Test, temp, def, and Ver for fixture control and information.
Explains functions controlled in 1-channel (Strobe) and 2-channel (Strobe, Intensity) DMX modes.
Explains functions controlled in 3-channel DMX mode: Intensity.
Details functions in 4-channel DMX mode: Intensity, Flash duration, Flash rate, and Special effects.
Details functions in 6-channel DMX mode: RED, GREEN, BLUE intensity, Master dimmer, Flash Duration, and Flash Rate.
Details functions in 7-channel DMX mode: RED intensity, GREEN intensity, BLUE intensity, Master dimmer, Flash Duration, Flash Rate, and Special Effects.
Instructions on how to safely replace a fuse, emphasizing using the correct type and rating.
Safety precautions regarding earthing, voltage, cleaning with a moist cloth, and avoiding liquids.
Explains how flash intensity and duration can be set across different DMX channel modes.
Details the range of flash duration settings in milliseconds for 50 Hz and 60 Hz power supplies across DMX modes.
Details the range of flash rates in flashes per second for 50 Hz and 60 Hz power supplies across DMX modes.
To Next Page