Quick Installation Guide
Indoor FHD IP Camera with P2P
V1.1
EQC00005
"Foscam" App download
LAN
WPS/Reset
Power
Power/Network light
Micro SD Card Slot
High-Power IR LED
Induction IC
Lens
PIR
Light Status Description
Constant Flash(green) Wired connection
Flashing(green) every 0.2 seconds EZLink takes eect (default)
Flashing(green) every 0.4 seconds WPS is connecting
Slow Flash(green) every 1.0 second Wi-Fi connected
Flashing(red) every 0.4 seconds Reset is started
1 Hardware Introduction
1. Turn on your wireless router.
2. Connect the power adapter to the camera.
Physical Description
1. Rotate the base of the camera until points a and bare
aligned, this allows for the mounting plate to be
removed.
2. Install the mounting plate on a wall or ceiling with
supplied xing screws.
3. Align points a and b to insert the camera base to the
mounting plate. Rotate so that points a and b are no
longer aligned, this attaches the camera securely to the
base.
a
a
b
b
Hardware Installation
Hardware Connection Light Status
Before you continue, please note:
Make sure your smartphone is located near the camera.
Do not use an ethernet cable to connect the camera
if you want to use a wireless connection. And the camera
will play voice prompts ”Ready for WiFi conguration” .
Make sure smartphone is connected to your wireless
router.
Package Contents
IP Camera
AC Adapter
CD-ROM
Quick Installation Guide
Warranty Card
USB Power Cable
WPS
Model: C2
Quick Installation Guide
Indoor FHD IP Camera with P2P
V1.0
EQC00003
"Foscam" App download
Model: C2
Security Warning
Foscam cameras and NVRs require good security
practices to safeguard your privacy. You should
regularly change your camera or NVR password
which is 8-10 numbers, letters, symbols combination.
You should update your camera or NVR regularly.
Make sure your camera or NVR has the latest
rmware installed for your specic model and better
experience.
To Next Page
Need help?
General
Weight and Dimensions
